One major cause of high loss is a poor cleaving surface. The 90S+ fusion splicer analyzes the condition of both L and R cleaving surfaces and performs optimal fusion control. This new technology significantly reduces loss and minimizes the risk of rework.
Fusion can be easily affected by environmental changes. The 90S+ fusion splicer uses real-time fusion parameter control by analyzing the light intensity of the fiber during fusion. This provides stable and reduced loss.
Active Fusion Control can vary the source parameters based on fiber type. The 90S+ fusion splicer automatically applies optimal source parameters depending on the fiber type.
Automatic Open-Close Protectors
The faster automatic features of the 90S+ fusion splicer reduce setup times. With this splicer, an operator can complete the entire splicing process, including splicing and heating, by just moving the fiber without touching the 90S+.
Reduction in Processing Time
The shape of the protective sleeve clamp is optimized for 60mm long protective sleeves. The length from the splice point to the edge of the protective sleeve clamp is 30mm. Therefore, it is easy to use your fingers to center the protective sleeve by referencing the splice point.
Fiber Holder Clamps
Fiber holder clamps support automatic operations. After splicing, when the protective sleeve clamps automatically open, the fiber holder clamps gently hold the spliced fiber to prevent it from slipping. The clamps are released when the fiber is removed by the operator.
These functions enable the 90S+ fusion splicer to reduce processing time by 50% compared to the previous model.
Carrying Case
The 90S+ fusion splicer can be used in multiple ways with the carrying case. The 90S+ fusion splicer is ready for immediate use by opening the case, but depending on the work environment, it can also be used on top of the carrying case or just with the work tray.
Work Tray
The work tray has many functions. It features two drawers for storage, large enough to hold tools or battery packs. Additionally, the work tray can be split into two, allowing it to be configured to suit your work area.
Loose Tube Compatibility
The sleeve clamp of the 90S+ fusion splicer is compatible with loose tube fibers. The protruding part of the sleeve clamp for loose tube fibers can be adjusted by hand without tools, allowing it to be opened or retracted.
Tool-Free Electrodes and Illumination
The electrodes of the 90S+ fusion splicer come "pre-installed," including the corrected screws. You can turn the screws by hand without tools, making electrode replacement easy.
Whatsapp
Phone